For such a detailed print it was fine, though there was quite a few beading issues. I'm grateful I didn't use FDM. I also see it went to the 60mm of the model which was fine because even at 60mm it was a bit hard. So it was a good job for a tough model but I think I may need to refine things a bit. Also my correction either was too tiny or came too late but given the beading it's not exactly the most of the problem. I need to explore other manufacturing technologies or just talk to The Dice Lab again. You did the best you could with a difficult model and are not at fault. This whole order was an experiment. As are some of my other orders on Treatstock.
3D Printer Filaments 
