Simple uBitX case with holes for a 16mm mic plug, phones connector, power switch, volume (stock), rotary encoder, nextion 3.2 display, and a speaker. The back panel
...Plus has holes for an SO-239 and power, as well as a square hole for the heat sinks.
The fuse holder is 15mm and acquired through amazon via:
https://www.amazon.com/gp/product/B012CTCWES
The display I used was Itead branded:
https://www.amazon.com/gp/product/B015DMOYHY/
The mic connector I used was 16mm x 8 pin with PTT, Mic, CW key, & Audio passed through.
https://www.amazon.com/gp/product/B07DC7WRWN/
The audio was tapped off with a .1 uF ceramic cap from the volume sweeper. My soundcard is ok with this, ymmv.
Mic plug pin out:
pin 1 - ptt
pin 2 - ptt gnd
pin 3 - mic
pin 4 - mic gnd
pin 5 - key/resistor to pin 6
pin 6 - + 5v
pin 7 - audio - .1 uF cap from volume sweeper
pin 8 - audio gnd
