Replacement part for PRIMO model # 900127 (PRIMO does not have this replacement part on their website, can't find on google either). My sisters water cooler
...Plus probe broke where the 4 tabs (3 of 4 were broken) on the bottom latch to the unit. All pictures show the original part with the broke tabs and and the newly printed part. Remove the lower disk ring seal and the shaft seal and place on the newly printed probe. New probe was acetone coated for a smoother finish.
Printer: Lulzbot AO-101 (Calibration still needs some work :)
Design software: DesignSpark mechanical
Slice engine: Cura / Matter control
Layer height: 0.12mm
Infill: 100%
Supports needed: 2mm spacing 1mm away from object in a grid
Print time: 7 hours
